8C-32 - HURTH DOWN ANGLE TRANSMISSION 90-823225--1 1096
Output Shaft Seal
1. If bearing were not replaced and no shimming
is required, push new seal onto special mandrel.
Ensure seal will be positioned with lip of seal fac-
ing inward. Drive seal uniformly into bore of hous-
ing to the point that it is countersunk .040 in. (1
mm) with reference to housing surface.
71061
a
a - Seal
Suction Pipe
1. Reinstall suction pipe seal in bottom of oil filter
bore. Coat seal with ATF (automatic transmission
fluid).
27660
a
a - Seal
2. Reinstall suction pipe. Place one drop of Quick-
silver Loctite 8831 on screw threads. Then se-
cure suction pipe down with retainer plate. Tight-
en screws securely.
3. Bend tabs down over screws.
71060
Shafts and Baffle Plate
1. Coat tapered roller bearings with ATF.
2. Install output shaft.
71058
To Next Page
Loading...
