NOTICE
Using propylene glycol antifreeze in the closed cooling system can damage
the cooling system or the engine. Fill the closed cooling system with an
ethylene glycol antifreeze solution suitable to the lowest temperature to which
the engine will be exposed.
The coolant section of the closed cooling system must be filled with a 50/50
mixture of Extended Life Antifreeze/Coolant and distilled water.
Tube Ref
No.
Description Where Used Part No.
122
Extended Life
Antifreeze/Coolant
Closed cooling system 92-877770K1
NOTE: Coolant section capacity is approximate.
8.2 Models
Capacity Fluid Type
Closed cooling
system
17.4L (18.4 US qt)
Extended Life
Antifreeze/
Coolant
!
CAUTION
A sudden loss of pressure can cause hot coolant to boil and discharge
violently resulting in serious injury from burns. Allow the engine to cool down
before removing the coolant pressure cap.
IMPORTANT: When filling the coolant section after it has been completely
drained, the engine should be level or slightly lower at the flywheel end.
1. Remove the pressure cap from the coolant reservoir.
2. Fill the reservoir to the full mark with the recommended coolant solution.
3. When refilling the coolant section after it has been completely drained, fill
the reservoir to within 12 mm (0.50 in.) of the top of the reservoir neck
before starting the engine.
4. Replace the pressure cap.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other
components will overheat and suffer damage. Provide a sufficient supply of
water to the water inlets during operation.
5. Supply cooling water to the engine.
MAINTENANCE
56 eng
To Next Page
Loading...
