Maintenance
and care
245
CAUTION: THE VERTICAL AIM
MUST BE ADJUSTED FIRST.
You will need a 6 mm Allen wrench
or a Phillips screwdriver.
If the vehicle has been in an
accident, the vehicle's front
structure should be properly
aligned before aiming the
headlamp.
Adjusting
the vertical aim
1. Park the vehicle
.
2. The vertical indicator is located
on top of the headlamp assembly;
the adjusting screw is located
behind the headlamp assembly.
3. Turn the vertical adjusting
screw until the bubble aligns with
the 0" reference mark when
viewed from directly above. The 0"
reference mark is the middle of the
three (3) bold graduation marks.
To Next Page
Loading...
