Engine Guardian System
The Engine Guardian system monitors the critical sensors on the engine for any early indications of problems. Engine Guardian
is functional whenever your engine is operating, so you never have to be concerned about whether or not you are protected.
The system will respond to a problem by sounding the warning horn for six seconds and/or reducing engine power in order to
provide engine protection.
If Engine Guardian has been activated, reduce the engine speed. The problem will need to be identified and corrected. The
system must be reset before the engine will operate at higher speeds. Moving the throttle lever back to the idle position will
reset the Engine Guardian system. If the Engine Guardian system has determined the reset has not corrected the problem,
Engine Guardian will remain activated, limiting the throttle. The problem must be identified and corrected before Engine
Guardian will allow the engine to reach a normal operating RPM.
Controls
Switches
Four‑Position Key Switch
•
"OFF" ‑ In the "OFF" position, all electrical circuits are off. The engine will not operate with
the key switch in the "OFF" position.
•
"ACC" ‑ In the "ACC" position, any accessories connected to the electrical circuits can be
operated. The engine will not operate with the key switch in the "ACC" position.
•
"ON" ‑ In the "ON" position, all electrical circuits and instrumentation receive power. The
engine can be started with an optional start‑stop switch.
•
"START" ‑ Turn the key to the start position and release to start the engine.
NOTE: The key can only be removed with the key switch in the "OFF" position.
Dual‑Engine Start‑Stop Switch
A start‑stop switch is optional equipment. The start‑stop switch works in conjunction
with the key switch. There is one start‑stop switch for each engine. Each button on a
multiengine start‑stop switch functions independently. The key switch must be in the
run position to start a stopped engine with the start‑stop switch. Pressing a start‑stop
switch button when an engine is running will shut down the corresponding engine.
Bilge Blower Toggle Switch
Operates the bilge blower, if equipped.
Section 1 - Getting to Know Your Power Package
90-8M0133568 eng JUNE 2017 Page 7
To Next Page
Loading...
