Electrical network protection
Sepam series 20
Sepam series 40
Quick start
PE50465
Storage
Sepam may be stored in its original packaging in a closed
sheltered location:
b ambient temperature: -25 °C ... +70 °C (or -13 °F ... +160 °F)
b relative humidity y 90 %.
Periodic checking of the storage environment and of the packaging
on a yearly basis is recommended.
Commissioning
Once installed, the Sepam must be energized as soon as possible,
especially in a damp location (humidity u 90 %).
Storing an unenergized and unpackaged Sepam for a long period
may damage the unit.
Identification
Each Sepam comes in a single package that contains the base
unit and its connector.
Other optional accessories such as modules, current or voltage
input connectors and cables come in separate packages.
To identify a Sepam, check the 2 labels on the right side panel of
the base unit that describe the firmware and hardware features of
the product:
b hardware equipment label (for instance Sepam series 20)
DANGER
HAZARD OF ELECTRIC SHOCK, BURN
OR EXPLOSION
b turn off all power supplying the Sepam
and the equipment in which it is installed
before working on it.
b always use a proprely rated voltage
sensing device to confim that power is off.
b replace all devices, doors, and covers
before turning on power to this equipment.
b before energizing the power equipment,
replace all barriers and covers.
Failure to observe this instruction will
result in death, serious injury or
equipment damage.
DE80191
b firmware equipment label
DE80197
For more informations, please refer to "Sepam series 20
Installation and user’s manual" PCRED301005EN or
"Sepam series 40 Installation and user’s manual"
PCRED301006EN.
59607
Series 20/advanced UMI/24-250V
Séries 20/IHM avancée/24-250V
59607
Test PASS: 12/14/2006
Operator: C99
S10UD
Final testing:
date and
operator code
To Next Page
Need help?
General