• ALL INSTALLATION OPERATIONS MUST BE CARRIED OUT WITH THE ENGINE OFF.
• Before starting installation, carefully asses the position of the device, according to the available space, to the length
of the power cables, and to the horizontal position that it needs to maintain.
• The product needs to be installed in an area that is only accessible to the service sta (Service Access Area On).
• Carefully follow the steps outlined in this manual.
• Installation sta are not authorised to remove warranty seals and/or access the inside of the product and accesso-
ries.
• The sta in charge of the installation is not authorised to alter and/or adapt the product and its relative accessories.
• The manufacturer assumes no responsibility for damages caused to property and/or people, caused by the in-
correct installation of the product.
• ATTENTION: Risk of explosion if the internal batteries are replaced with non-equivalent models, other than those
contained in the product.
INSTALLATION MANUAL
MOTORCYCLE TELEMATIC ALARM
T.30 - Def-Com 30
EN
5040342900-WEB
KIT COMPOSITION
WARNINGS
A
ALARM
CONTROL UNIT
B
ALARM
WIRING
E
ALARM
ACCESSORY BAG
G
DETERGENT
WIPE
D
TELEMATIC
CONTROL UNIT
C
CONNECTION
HARNESS
F
TELEMATIC
ACCESSORY BAG
Power supply: ...............................................................................................................12Vdc (10V-15V)
Working temperature: ...........................................................................between -25°C and +85°C
Protection rating: .............................................................................................................................. IP 65
Application classi cation: .................................................................................................motorcycle
ALARM CONTROL UNIT: TECHNICAL SPECIFICATIONS
Power supply: ..............................................................................................................12Vdc (10V-24V)
Working temperature: ......................................................................... between -30°C and +80°C;
Protection rating: ............................................................................................................................. IP 65
Application classi cation: .................................................................................................motorcycle
TELEMATIC CONTROL UNIT: TECHNICAL SPECIFICATIONS