36 37
Not a Medical Device
The headset and accessories are not medical devices,
and are not intended to diagnose, treat, cure, or
prevent any disease.
Keep Away from Pets
To avoid damage, keep your headset, charger, cables
and accessories away from pets.
Regulatory Information
FCC Information
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Changes or modifications to a Product by the user that are
not expressly approved by the party responsible for compliance could make
the Product no longer comply with the FCC Rules.
Information Regarding Exposure to Radio Frequency Energy
The Device meets the FCC Radio Frequency Emission Guidelines and are
certified with the FCC. Information on these Products is on file with the
FCC and can be found by inputting such Product’s FCC ID (which can be
found on the bottom of the Device into the FCC ID Search form available at
transition.fcc.gov/oet/ea/fccid
after searching on the FCC ID for your device
which can be found in the setting manual under regulatory information.
The Device complies with FCC RF radiation exposure limits. During testing,
the device is set to the highest transmission levels and places in positions
that simulated uses against the head with no separation, and when worn or
carrier against the body, with 5mm separation.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
This device is restricted to indoor use.
Operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment.
The transmitter module may not be co-located with any other transmitter
or antenna.
CAN ICES-3 (B)/NMB-3(B)
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
i. The device for operation in the band 5150–5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
To Next Page
Loading...
