19
COMPLIANCE AND REGULATORY INFORMATION
REGULATORY INFORMATION – UNITED STATES
FCC Information
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Changes or modifications to a device by the user that are not expressly approved
by the party responsible for compliance could make the device no longer comply with the FCC
Rules and void the user’s authority to operate the equipment.
Information Regarding Exposure to Radio Frequency Energy
These devices meet the FCC Radio Frequency Emission Guidelines and are certified with the FCC.
Information on these devices is on file with the FCC and can be found by inputting such device’s
FCC ID (which can be found on the device) into the FCC ID Search form available at
transition.fcc.gov/oet/ea/fccid.
These devices comply with FCC RF radiation exposure limits. Important regulatory compliance
marks are placed under the right strap of the headset.
REGULATORY INFORMATION - CANADA
Industry Canada: This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
To Next Page
Loading...
