ENGLISH en
7
You must not perform any work other than that
described here.
In the event of misuse, improper operation or
unprofessional repair work no liability shall be
assumed by us for any damage incurred.
When the appliance is not in use, leave the hose on
the appliance to prevent dust accidentally
escaping.
Do not operate appliances or accessories under the
following conditions:
- If the appliance has recognisable damage
(cracks/breaks),
- If the mains connection lead is defective or shows
signs of cracking or ageing,
- If there is a suspected non-visible defect
(after a fall).
Do not point the nozzle, hose or tube at people or
animals.
If any foam or water egresses, switch off
immediately. Empty the container and, if need
be, the pleated filter.
Never sit or stand on the appliance.
Always set up the connection lead and hose so
there is no danger of tripping.
Do not pull the connection lead over any sharp
edges and do not kink or pinch it.
If the connection lead of the appliance is damaged,
it must be replaced by a special connection lead.
See the chapter on Repairs.
Always connect to a socket with protective contact.
Do not use any damaged extension leads.
Never insert or remove the mains plug with wet
hands.
Only pull on the mains plug, not on the lead.
The plug socket on the appliance may be used only
for the purposes defined in the usage instructions.
Do not leave the appliance unattended. If there is a
long work interruption, disconnect the mains plug.
The vacuum cleaner should not be used or stored
outside in wet conditions.
IMPORTANT - This machine must only be stored
indoors.
Acids, acetone and solvents can corrode the
appliance components.
Prior to any servicing work, clean the
appliance. Switch off the appliance after each
use and pull out the mains plug.
Steam cleaners and high-pressure cleaners must
not be used to clean the vacuum cleaner.
The inside of the cover must always be kept dry.
Mold contamination can result if the appliance is not
cleaned for an extended period, especially if used in
areas where foodstuffs are processed: Always
clean and disinfect the vacuum cleaner immediately
after use.
Never open the appliance outdoors during rain or
storms.
The appliance must not be operated in areas with
an explosion hazard.
Ensure that the vacuum cleaner is steady.
If the extracted air is discharged into the room,
ensure there is an adequate air change rate (L) in
the room. Observe the regulations that apply in your
country.
Caution! This appliance contains dust that is
harmful to health. Discharge and
maintenance operations (including disposal
of the dust collection containers) must only be
carried out by qualified specialists wearing
appropriate protective clothing and equipment.
Warning - general danger!
Caution! Do not use the appliance until you
have read the Operating Instructions.
WARNING - Operating staff must be provided with
appropriate instruction on how to use this vacuum
cleaner.
While the appliance is suitable for extracting
substances that pose a slight threat to health, it is
not appropriate for reducing wood dust in inhaled
air.
Additional Warnings:
California Prop 65 08_2018
Some dust created by power
sanding, sawing, grinding,
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemicallytreated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
Observe the applicable regulations in your country
for the f
ilter cartridges
. The filter cartridges (made of
polyester) that are contained in the delivery comply
with dust class M (filters trap 99.9 % of all dusts as
of Ø 3 µm). HEPA filter cartridges see chapter11.
Accessories.
The total maximum permissible current
consumption (of dust extractor and connected
unit) must not exceed the value I
max
(see table,
page 3). You can reduce the current
consumption of the vacuum cleaner with the
"Current Control" feature, and thus adapt it to
the on-site conditions. See chapter 6.3. If the
current consumption is too high, the vacuum
cleaner or the wiring can overheat and cause a
fire.
To Next Page
Loading...
Need help?
General
