ENGLISH en
17
Only pull on the mains plug, not on
the lead.
WARNING - The plug socket on
the device must be used only for
the purposes defined in the
operating Instructions.
Do not leave the device
unattended. If there is a long work
interruption, disconnect the mains
plug.
The vacuum cleaner should not be
used or stored outside in wet
conditions.
IMPORTANT - This machine must
only be stored indoors.
Acids, acetone and solvents can
corrode the device components.
Prior to any servicing work,
clean the device. Switch off the
device after each use and pull out
the mains plug.
Steam cleaners and high-pressure
cleaners must not be used to clean
the vacuum cleaner.
The inside of the cover must
always be kept dry.
Mould contamination can result if
the device is not cleaned for an
extended period, especially if used
in areas where foodstuffs are
processed: Always clean and
disinfect the vacuum cleaner
immediately after use.
Never open the device outdoors
during rain or storms.
Do not use the device outdoors in
cold weather.
The device must not be operated in
areas with an explosion hazard.
Ensure that the vacuum cleaner is
steady.
If the extracted air is discharged
into the room, ensure there is an
adequate air change rate (L) in the
room. Observe the regulations that
apply in your country.
Keep the tool socket dry and do not
expose to moisture.
Do not plug extension cords
between the vacuum cleaner and
the power tool.
When using the tool socket, use
the vacuum cleaner in a dry envi-
ronment.
Caution! This device contains
dust that is harmful to health.
Discharge and maintenance
operations (including disposal of
the dust collection containers)
must only be carried out by
qualified specialists wearing
appropriate protective clothing and
equipment.
Warning - general danger!
Caution! Do not use the
device until you have read the
operating Instructions.
WARNING - Operating staff must
be provided with appropriate
instruction on how to use this
vacuum cleaner.
Special safety instructions for
ASR 35 M ACP:
Warning sign for machines with
dust class M:
During discharge and maintenance
operations, note the following:
Clean the device before opening it.
Wear a dust mask. Avoid exposing