ENGLISHen
6
- Depending on the machine to be fitted, tighten the
pins (10) with the screws through the front or rear
holes.
- Mount guide plate 6.31019 on the guide rail. (The
groove (9) in the guide plate 6.31019 slides in the
profile (3) of the guide rail)
-Mount the circular saw with bores of the guide
plate on the pins (10) of the guide plate 6.31019.
- With the screws (8) released, the play, and thus
the sliding movement of the guide rail, can be
adjusted by shifting the screws.
The guide plate has several bores, which also
makes the machine suitable for diagonal cuts along
the guide rail. The cutting angles are annotated
beside the bores.
To Next Page
Loading...
