IMPORTANT! READ BEFORE UNBOXING
Quick start guide for MD-33
Steps:
1. Two (2) people are required for the initial setup.
2. Carefully unpack your new walk thru metal detector.
3. After unpacking, you should have the following:
4. On a Flat Clean surface, set the head module on the pad provided.
The head unit should be face down with the LED screens facing the
ground. Once the head module is positioned correctly; insert the keys
to open and access the motherboard.
5. Attach the Left and Right Uprights/Legs using the Bolts Provided -
DO NOT OVER TIGHTEN
To Next Page
Need help?
General
