Page 5
1. Install the charging station as described on the Page 1.
2. Switch ON charging station power supply.
3. Set the main fuse rating to 35A (needed only if it has been changed - factory default setting is already 35A)
via front PUSH BUTTON + status LED blinks as described on Page 3.
4. Activate main fuse protection dynamic charging RF receiver via front PUSH BUTTON + status LED blinks as
described on Page 3 (by default the RF receiver is not activated).
5. If necessary set the other parameters via front PUSH BUTTON + status LED blinks as described on Page 3.
6. Install and set the 3FD-2 DYNAMIC EV CHARGING UNIT as described on pages 7, 8 and 9.
WIRELESS 1 or 3-phase MAIN FUSE protection DYNAMIC
charging with 1 or more WALL MOUNTED charging stations
To Next Page
Loading...