Connection
For the installation you will need 2 pieces of cable. The first
one, roughly 1,5m (5ft) to go from the LNB to the motor,
the second one as long as it takes to go from the motor to
the receiver.
Prepare the cables and assemble the “F” plug at the end of
the cable.
Respect the dimension indicated on the diagram 4; the
plug must screw on the aluminium foil rolled up on the
outer sheath. Make sure that none of the braid strand is in
contact with the central core of the cable.
Connect the receiver to the television set with a scart
lead. Put the motor near the receiver, on a table or on the
floor, and connect the receiver LNB input to the Motor
RECEIVER output with the 1,5m (5ft) cable, then switch on
the receiver.
To Next Page
Loading...