(4)
Go to corresponding
paragraph page 4 and 5
H
Assemble the satellite dish on the motor
• Assemble the satellite dish and fix it on the motor’s stem.
The satellite dish U-Bolt must be as low as possible on
the stem. As the motor is at 0°, make sure you perfectly
align the dish offset arm with the motor (diagram H1).
In order to prevent the dish from falling down in case of
breakdown of the U-screw of the dish, we advise you to
put the security-bolt (marked 4 on the figure page 9). If
this bolt is to short to maintain the U-screw, link it to the
dish with the help of a strong wire.
• Direct approximately the whole set(satellite dish + rotor)
towards the south. Adjust the angle on the back support
of the dish, so that the dish is vertical.
• Switch on the receiver.
• Do a continuing rotation
(4)
until the stop 75° East and
75° West to check if there is no obstacle. If you get close
from an obstacle during the rotation, go to paragraph N
page 23 to adjust your electronic limits.
• Put the receiver on the Hotbird reference channel.
G
Satellite dish assembling
Assemble the different parts of the satellite dish (see the
user manual included with it).
To Next Page
Loading...