Prepare the motor (see diagram 2)
Assembling
• Make sure the fixing (tube or stand off arm) is stable and
strictly vertical. An error bigger than 1 degree (2 cm, or
3/4 inch per meter) from the vertical will preclude the
motor for working properly. If necessary, add some block
between the wall and the fixing. Check the verticality
with a spirit level or a plumb line.
• Assemble together the parts of the motor (diagram 2).
Put first the U-screws (1) through the part (2). While
assembling the part (2) with the body, pay attention to
the washer (3) : the part labelled «down» must be placed
on the bottom, as shown on the picture.
• Once the motor is assembled, do not fix it straight away
on the mast or the stand off arm, some operations needs
to be done near the receiver first.
C
To Next Page
Loading...