Made by ALL Engineering
Remote control
The remote control is made to control the available digital inputs, volume and muting. As
opposed to the front panel buttons were you can select one of the digital sources directly , the
remote will toggle through the entire range of available digital sources.
When the Adagio is set into the stand-by mode, it will remember the last input selection and is
available again when the Adagio is switched on.
Replacing the batteries
If one of the buttons is not activated there is no power consumption at all which leads to a very
long battery life cycle. The two batteries used has the following type: CR1632 3 Volts.
Batteries can be replaced on the following way:
Use a middle sized Philips screw driver to remove the screws from the back of the remote.
By removing the back cover the printed circuit board will be visible.
To Next Page
Loading...