MG 40 Series - Basic Setting Operation and Instructions; Basic Setting Operation

2040DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
2.2 BASIC SETTING OPERATION AND INSTRUCTIONS
This section describes basic operation and instructions when setting parameters.
2.2.1 BASIC SETTING OPERATION
Parameters can be grouped into three setting types, “setting value selection”, “decimal point position selection” and “numeri-
cal value setting”. Basic operation of each type is as shown below.
■ SETTING VALUE SELECTION
1
Press SHIFT button to show the setting.
• The current set value is indicated.
2
Press UP button to select your desired setting value.
3
Press SHIFT button to apply the new setting.
• The setting item is indicated.
■ DECIMAL POINT POSITION SELECTION
1
Press SHIFT button to show the setting.
• The current set value is indicated.
2
Press UP button to select a desired decimal point position.
3
Press SHIFT button to apply the new setting.
• The setting item is indicated.
*1 Display depands on the settings.
*1 Display depands on the settings.