MG 40 Series - Page 21

2140DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
NOTE
■ MOVING THE DECIMAL POINT
Pressing U
P button moves the decimal point one place to the left.
3 decimal places (10
-3
)
2 decimal places (10
-2
)
1 decimal place (10
-1
)
No decimal point
■ DECIMAL POINT POSITION
“No decimal point” to “3 decimal places” can be selected in the decimal point position setting.
SETTING VALUE FUNCTION SETTING VALUE FUNCTION
No decimal point 2 decimal places (10
-2
)
1 decimal place (10
-1
) 3 decimal places (10
-3
)
■ NUMERICAL VALUE SETTING
1
Press SHIFT button to show the setting.
• The current set value is indicated.
2
Press SCALE/↑ button to shift the display into the setting standby
mode.
• The most signicant digit starts blinking.
3
Press DISP/↓ or SCALE/↑, and UP buttons to set a numerical value.
• Press D
ISP/↓ or SCALE/↑ button to go to the next digit.
• Press U
P button to change the blinking value.
4
Press SHIFT button to apply the new setting.
• The setting item is indicated.
*
1 Display depands on the settings.