2240DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
NOTE
■ SHIFTING DIGITS
• Each time pressing S
CALE/↑ button, the blinking digit moves to the right.
• Each time pressing DISP/↓ button, the blinking digit moves to the left.
■ SETTING A NUMERICAL VALUE
• Each time pressing U
P button, the numeral is incremented by 1.
• The negative sign (-) must be set together with the 4th digit. For example, set ‘-004.0’ instead of ‘-4.0’.
• 4th digit
• Other digits
2.2.2 INSTRUCTIONS ON BASIC OPERATION
■ IF THE FRONT BUTTONS ARE LEFT UNTOUCHED…
• The setting item is indicated without applying the last changes after approximately 1 minute while it is in the setting
standby mode.
• The setting item is indicated after approximately 1 minute while the set value is indicated in setting a numerical value.
• The display goes back automatically to Measuring Mode after approximately 1 minute while the setting item is indicated.
■ TO ABORT A SETTING…
• If you get lost in a setting mode, you can execute initialization. Refer to 12.2 INITIALIZING SETTING VALUES.
To Next Page
Loading...
