MG 40 Series - Step 1. Decimal Point Position; Decimal Point Position List; Operating Procedure

2540DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
3.1 STEP 1. DECIMAL POINT POSITION
3.1.1 DECIMAL POINT POSITION LIST
Default values of decimal point position are as shown in the following tables.
INPUT SIGNAL DEFAULT VALUE
A1: 0.00 – 20.00 mA AC
2 decimal places (10
-2
)
A2: 0.0 – 200.0 mA AC
1 decimal place (10
-1
)
A3: 0.000 – 2.000 A AC
3 decimal places (10
-3
)
A4: 0.000 – 1.000 A AC
3 decimal places (10
-3
)
A5: 0.000 – 5.000 A AC
3 decimal places (10
-3
)
3.1.2 OPERATING PROCEDURE
1
Conrm the wiring, and turn on the power.
• All the indications turn on for approximately 3 seconds and then the
display moves on to Measuring Mode.
NOTE
Indication ‘S.ERR’ may blink, which shows the input out of the permis-
sible range and does not show the unit failure.
2
3,4
3
■
Immediately after power on (all indicators on)
■ Measuring Mode
*1 Display depends on the settings and input.