MG 40 Series - Step 4. Display Scaling Value a; Display Scaling List; Operating Procedure

3140DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
3.4 STEP 4. DISPLAY SCALING VALUE A
3.4.1 DISPLAY SCALING LIST
Display scaling default values per input code and setting range (permissible display range) are as shown in the following
table.
INPUT SIGNAL DEFAULT VALUE SETTING RANGE
A1: 0.00 – 20.00 mA AC
Display scaling value A:
Display scaling value B:
to
A2: 0.0 – 200.0 mA AC
Display scaling value A:
Display scaling value B:
A3: 0.000 – 2.000 A AC
Display scaling value A:
Display scaling value B:
A4: 0.000 – 1.000 A AC
Display scaling value A:
Display scaling value B:
A5: 0.000 – 5.000 A AC
Display scaling value A:
Display scaling value B:
3.4.2 OPERATING PROCEDURE
1
Conrm the wiring, and turn on the power.
• All the indications turn on for approximately 3 seconds and then the
display moves on to Measuring Mode.
NOTE
Indication ‘S.ERR’ may blink, which shows the input out of the permis-
sible range and does not show the unit failure.
3,5
2,3,
4,5
4,6
5
■
Immediately after power on (all indicators on)
■ Measuring Mode
*1 Display depends on the settings and input.