3240DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
2
Hold down SCALE/↑ button for 3 seconds or more to move on to
Scaling Setting Mode.
• The setting item ‘D PT’ (decimal point position) is indicated.
3
Press DISP/↓ or SCALE/↑ button to go to the display scaling value A
setting.
• The setting item ‘D ZR’ (display scaling value A) is indicated.
NOTE
Skip to Step 7 if the default value is acceptable.
4
Press SHIFT button to show the setting and SCALE/↑ button to shift
the display into the setting standby mode.
• The forth digit starts blinking, to which you can apply changes.
5
Press DISP/↓ or SCALE/↑, and UP buttons to set to ‘000.0’.
• Press D
ISP/↓ or SCALE/↑ button to go to the next digit, and UP button to
change the blinking value.
NOTE
• ‘000.0’ is a display example. Set any value within the range of -9999 to 9999.
• The negative sign (-) must be set together with the 4th digit. For example, set ‘-04.00’ instead of ‘-4.00’.
6
Press SHIFT button to apply the new setting.
• And the setting item is indicated.
7
■ TO GO ON TO SET THE DISPLAY SCALING VALUE B,
Skip to Step 3 in “3.5 STEP 5. DISPLAY SCALING VALUE B”.
■ TO QUIT,
Hold down D
ISP/↓ or SCALE/↑ button for 1 second or more to return to Measuring Mode.
Blinking
Blinking
To Next Page
Loading...
