1743DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
2. BASIC SETTING OPERATION AND INSTRUCTIONS
This section describes basic operation, attachment and removal of the front cover, and instructions when setting param-
eters.
2.1 ATTACHING/REMOVING FRONT COVER
• Set parameters with the buttons inside the front cover. Remove the cover in setting.
• Attach the cover after conguration.
■ REMOVING FRONT COVER
(1) Pinch the dimples at both sides (designated as A in below).
(2) Pull up at the bottom of the cover.
■ ATTACHING FRONT COVER
(1) Fit the convex part of the cover in the concave part of the meter.
(2) Push the cover bottom until it clicks into place.
NOTE
• Be sure to conrm the direction of the front cover in attaching.
• Make sure that there is no misalignment or space between the unit and the cover after attaching.
Concave part
Convex part
To Next Page
Loading...
