MG 43 Series - Page 19

1943DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
■ SETTING VALUE SELECTION
1
Press SF button to shift the display into the setting standby mode.
• The current set value starts blinking.
2
Press UP button to select your desired setting value.
3
Press DI or SC button to apply the new setting.
• The next or previous parameter setting is indicated.
■ DECIMAL POINT POSITION SELECTION
1
Press SF button to shift the display into the setting standby mode.
• The current set value starts blinking.
2
Press UP button to select a desired decimal point position.
3
Press DI or SC button to apply the new setting.
• The next or previous parameter setting is indicated.
*1 Display depands on the settings.
*1 Display depands on the settings.