MG 43 Series - Instructions on Basic Operation

2043DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
NOTE
■ MOVING THE DECIMAL POINT
Pressing U
P button moves the decimal point one place to the left.
3 decimal places (10
-3
)
2 decimal places (10
-2
)
1 decimal place (10
-1
)
No decimal point
■ DECIMAL POINT POSITION
“No decimal point” to “3 decimal places” can be selected in the decimal point position setting.
SETTING VALUE FUNCTION SETTING VALUE FUNCTION
No decimal point 2 decimal places (10
-2
)
1 decimal place (10
-1
) 3 decimal places (10
-3
)
2.2.1 INSTRUCTIONS ON BASIC OPERATION
■ IF THE FRONT BUTTONS ARE LEFT UNTOUCHED…
• The indication turns on with applying the last changes after approximately 1 minute while it is in the setting standby mode.
• The display goes back automatically to Measuring Mode after approximately 1 minute in one of the other modes.
■ TO ABORT A SETTING…
• Hold down S
F button for 3 seconds or more to return to Measuring Mode without applying the last changes while the
display is in the setting standby mode.
• If you get lost in a setting mode, you can execute initialization. Refer to 12.2 INITIALIZING SETTING VALUES.