3043DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
4
Press SF button to shift the display into the setting standby mode.
• The forth digit starts blinking, to which you can apply changes.
5
Press SF and UP buttons to set to ‘10.00’.
• Press S
F button to go to the next digit and UP button to change the
blinking value.
NOTE
• ‘10.00’ is a display example. Set any value within the range of -1999 to 9999.
• The decimal point position depends on the decimal point position setting. Disregard the decimal point here.
• The negative sign (-) must be set together with the 4th digit. For example, set ‘-04.0’ instead of ‘-4.0’.
6
Press DI or SC button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press DI button, and the decimal point position will be indicated.
• Press S
C button, and the display scaling value A will be indicated.
7
■ TO GO ON TO SET THE DECIMAL POINT POSITION,
Skip to Step 3 in “4.3 STEP 3. DECIMAL POINT POSITION”.
■ TO QUIT,
Hold down D
I or SC button for 1 second or more to return to Measuring Mode.
Blinking
Blinking
To Next Page
Loading...
