3343DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
4
Press SF button to shift the display into the setting standby mode.
• The indication starts blinking, to which you can apply changes.
5
Press UP button to select the decimal point position.
• Select 1 decimal place (10
-1
).
• Press U
P button to move the decimal point.
NOTE
The right gure shows a display example. Select one among “no decimal point”, and “1 decimal place” to “3 decimal
places”.
6
Press DI or SC button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press DI button, and the display scaling value A will be indicated.
• Press S
C button, and the display scaling value B will be indicated.
7
Hold down DI or SC button for 1 second or more to return to Measuring Mode.
Blinking
Blinking
To Next Page
Loading...
