3443DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
5. OPERATION
Make sure that 0.0 – 100.0% is correctly indicated according to the input 4 – 20 mA DC provided.
IMPORTANT
Before operating, make sure that the wiring is correct, the input and the power supply are within the specication range.
1
Apply 4 mA input (0%) and make sure that 0.0% is indicated.
NOTE
■ WHEN THE FOLLOWING IS INDICATED…
• When ‘S.ERR’ is indicated, the input is not applied correctly. Check the input wir-
ing, equipment and signal.
Blinking
2
Apply 12 mA input (50%) and make sure that 50.0% is indicated.
3
Apply 20 mA input (100%) and make sure that 100.0% is indicat-
ed.
*1 Display depends on the settings and input.
To Next Page
Loading...
