MG 43 Series - Parameter Configuration

3543DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
6. PARAMETER CONFIGURATION
■ MODE
Parameters can be grouped in several modes. The 43DV2 has modes as shown in the following table. The mode transi-
tion depends on the input codes.
MODE FUNCTION MEASUREMENT
Measuring Normal measurement state where the unit takes in input. When the power is supplied,
the unit operates in Measuring Mode.
Measuring
Scaling Setting
*1
Basic settings such like display scaling value A and B, and decimal point position can
be performed.
Measuring stopped
Calibration
*2
0%, 50% and 100% input calibration can be performed.
Display Setting Moving average and brightness can be set. Settings can be initialized. Also the rm-
ware version can be conrmed.
*1 With process meter
*2 With DC voltmeter
■ MODE TRANSITION WITH PROCESS METER
• Transition from Measuring Mode to Each Mode
To Scaling Setting Mode Hold down SC button for 3 seconds or more.
To Display Setting Mode Hold down D
I button for 3 seconds or more.
• Transition from Each Mode to Measuring Mode
Hold down D
I or SC button for 1 second or more to return to Measuring Mode.
POWER ON
Measuring
Mode
Display Setting Mode
Hold down S
C
for ≥ 3 sec.
Scaling Setting Mode
for ≥ 3 sec.
Hold down D
I
for ≥ 1 sec.
Hold down D
I or SC
for ≥ 1 sec.
Hold down D
I or SC