MG 43 Series - Component Identification; Front View

843DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
1.4 COMPONENT IDENTIFICATION
■ FRONT VIEW
• With Front Cover
NOTE
• The engineering unit sticker label position is our recommended position.
• When an engineering unit is specied by the Ordering Information Sheet, the unit(s) will be shipped with the sticker
label put on the above position.
• Without Front Cover
COMPONENT FUNCTION
4-digit display Indicates present value, setting value and scaling error.
Range: -1999 to 9999
BUTTON FUNCTION
D
I Used to move on to the display setting mode; or to shift through setting items
in each setting mode.
S
C
Used to move on to the scaling setting
*1
or calibration
*2
mode; or to shift
through setting items in each setting mode.
S
F Used to move on to the setting standby status of each setting mode and to
shift through display digits in each setting item.
U
P Used to change setting values in a setting standby mode.
*1 With input codes ‘Sx’ (process meter, with scaling function)
*2 With input codes ‘Vx’ (DC voltmeter, without scaling function)
Engineering unit
sticker label position
Front cover