34
Lighting Switches
To switch on or off the headlamp, tail lamp
and parking lamp, please turn the end of the
combination switch control lever.
The light switch has 3 positions and they
represent different lighting functions:
OFF = All the lamps are turned off.
= The position lamp, license plate lamp,
instrument panel lamp and backlighting
lamp of all panels will turn on.
= The low beam lamp and all lamps
mentioned above will turn on under the
precondition that the ignition switch is
turned to ON position.
High Beam
To switch on the headlamp high beam:
Ensure that the ignition switch is in ON
position.
The headlamp is in the low beam state.
As shown in the figure, push the combination
switch control lever towards the instrument
panel.
The headlamp high beam indicator will turn
on when the headlamp high beam is turned
on. To switch from headlamp high beam to
low beam, pull the control lever towards
the opposite direction until it returns to the
normal position.
Warning
When approaching the on-coming vehicle
or the vehicle ahead, please do switch the
high beam to low beam. This is because
headlamp high beam will temporarily
blind other drivers, resulting in a collision.
Headlamp Flashing
To activate headlamp high beam flashing,
please pull the combination switch control
lever toward steering wheel and then release
it. The control lever will return to the normal
position.
Before releasing the control lever, keep the
headlamp high beam on.
Product Information
To Next Page
Loading...
