MG MG6 Series 2011 - Page 99

EngineMechanical-1.8T
Engine
9.Removecamshaftcarrier.
10.Removebothcamshafts.
11.Removeanddiscardoilsealsfromcamshafts.
Ret
1.Cleancamshafts.
2.Cleanmatingfacesofcylinderheadandcamshaft
carrier.
3.Cleancamshaftcarrierboltholesanddowels.
4.Blowoutoilwaysandlubricatecamshaftjournalsand
bearings.
5.Fitcamshaftsandpositioninletdrivepinat4o’clock
(120degrees)andexhaustcamshaftdrivepinat8
o’clock(240degrees).
6.Applya2mmcontinuousbeadofrecommendedsealant
toinsidepathsandoutsidepathsoncamshaftcarrieras
shownthenspreadtoanevenlmusingaroller.
Caution:Ensuresealantdoesnotblockoilways.
Caution:T oavoidcontamination,assemblyshouldbe
completedimmediatelyafterapplicationofsealant.
7.Fitcamshaftcarriertocylinderhead.
8.Fitandusingsequenceshown,progressivelytighten
boltssecuringcamshaftcarriertocylinderheadto
7–10Nm.
9.Cleancamshaftseallocationsandrunningsurfaces.
10.FitT10013toendofcamshafttoprotectseal.
11.Notingthatfrontsealsarecolouredblackandrearoil
sealsarecolouredred,tnewcamshaftoilsealsusing
Version2.083