MI AUDIO PTY. LTD. P.O. Box 6426, North Ryde, NSW 2113 Australia http://www.miaudio.com
MODE SWITCH
The mode switch is a new feature of the Cross Over Drive.
The middle position (STD) is identical to the original Cross
Over Drive.
The Low Gain mode has a similar tone to the standard
mode, but with perhaps a touch more low end early on in the
signal path. This is my favourite mode for on-the-verge-of-
breakup strat and tele tones.
The Tight mode has a similar amount of gain to the standard
mode. However, the frequency response is shifted more
towards the upper mids, with a tighter low end. This reduces
some of the fuzz of the standard mode, and creates a more
modern sounding pedal. It works especially well when you
need a bit of extra cut, or if you’re using very high output
humbuckers.
OTHER FEATURES
Tiny enclosure – I worked really hard to pack in a huge
amount of features into a tiny enclosure. Pedal-board real-
estate is very expensive these days! But don’t let size fool
you. This die-cast aluminium enclosure is very, very strong.
• The enclosure is professionally powder-coated and
silk-screened.
• The Cross Over Drive can be powered by an
internal 9V or an external 9V DC power supply. Please make
sure to use a well regulated negative centre pin supply. I also
recommend running the Cross Over Drive at 9V exclusively
for the best tone.
• Heavy duty 3PDT footswitch for true bypass and
absolutely no signal loss when bypassed.
REGISTRATION & WARRANTY
To register your pedal, you can email your name, contact
details, purchase date, and retailer details along with the
pedal serial number to: register@miaudio.com
Alternatively, you can send the above information to the
postal address on the front of this manual. PLEASE
REGISTER YOUR PEDAL. In the long run, it will be difficult
to have your pedal serviced if you need to if the pedal is not
registered.
This pedal carries a 5 year warranty that covers all repairs
due to manufacturer error. It does not cover any damage due
to user mishandling, shipping, acts of God, and abuse. The
owner should contact MI Audio directly for all repairs, and
any work done by anyone other than MI Audio voids the
warranty. All shipping costs are the responsibility of the
owner, and are to be paid in advance of any work performed
on the pedal. The owner may be asked to provide a copy of
the sales receipt for verification.
DISCLAIMER
The owner or user assumes responsibility for death, injury
and/or damages relating to the operation of this device. MI
Audio assumes no responsibility for death, injury or damages
relating from the operation of this device. I am always
thinking of ways to improve things, so all specifications are
subject to change without notice.
To Previous Page
Loading...