Digital Tyre Pressure Gauge With Keyring
Gauge Operation instructions:
1. Press”ON”button to activate the gauge.
2.The screen will flash and then show “0.0” with
default unit (Default units is PSI).
3. Press “ON” button for 3 seconds to switch to the next unit.
Repeatedly press “ON” for 3 seconds until desired unit shows.
4. Gauge is ready for operation.
5. Push and hold nozzle onto tyre valve, make sure a good
seal is made between the nozzle and the valve stem so
that no hissing sound of escaping air is heard.
6. Hold gauge on valve stem tightly, the display will flash until the
actual pressure reading is displayed and locked.
7. Promptly remove gauge from valve stem and read pressure. You
may continue to use the gauge even though the previous reading
is still displayed by following the instructions above.
8. The pressure reading will show (stay) on the screen for
about 10 seconds and gauge turns off automatically.
Torch Operation:
Press and hold the torch button to turn on the torch.
Release the torch button to turn it off.
Replacing the batteries:
To replace the batteries, simply unscrew the battery
cover on the back of the unit and remove the old
batteries. Insert 2 new CR2032 lithium batteries
ensuring correct polarity. Replace the battery cover.
Recycle spent batteries.
www.michelin-lifestyle.com
Distributed under license by ML Direct Ltd.
7
To Next Page
Need help?
General
