Thank you for purchasing the
MICHELIN programmable 12V High-Power
tyre inflator.
Please read the operating instructions carefully before using your inator. Improper use can
cause damage to property and possibly harm the user. When using the inator ensure the
vehicle is parked in a safe location, off the road, with the vehicle handbrake on and where
your personal safety is not at risk.
This inator can inate car tyres up to 50 psi (do not inate space saver tyres) and
bicycle tyres up to 100 psi. Higher pressures can be achieved in cycle tyres due to their
smaller air volumes compared to car tyres. Only suitable for vehicles with a negative
earth. Check your vehicle owner’s manual. When inating vehicle tyres this inator
should ONLY be used for car tyres and bicycle tyres. Low pressure items such as sports
balls and small inatable toys may also be inated using the adaptors provided.
MAX POWER REQUIREMENT DURING NORMAL USE: 10A / 120W
WARNING!
The inator contains no user serviceable parts – DO NOT OPEN.
Never allow children to use this tyre inator.
Inspect the tyre inator before each use.
Do not use the inator if bent, broken, melted, burnt, wet or any of the
components are damaged.
Do not leave connected to 12V DC socket unattended.
Do not kink or block the air hose while the inator is working.
Never overinate.
Under or overinated tyres can be dangerous.
Never run for more than 10 minutes. After each 10 minute run allow inator to
cool down.
Always ensure that regular weekly checks are carried out to the vehicle
manufacturer’s recommended pressures including the spare, but excluding space
saver tyres. Always check before a long journey or after loading or unloading
thevehicle.
Always check pressures in an ambient temperature, never immediately after a long
journey.
THIS PRODUCT COMPLIES WITH DIRECTIVE 2006/42/EC, ROHS DIRECTIVE 2011/65/EU
AND ANNEX VI OF DIRECTIVE 2000/14/EC.
USER GUIDE
High-Power TYRE INFLATOR
To Next Page
Loading...
Need help?
General