Installation Tips for Best Performance
To ensure best performance from this product DO NOT install the receiver on or
next to a metallic surface. If this is unavoidable then the antenna will need to be
brought clear of the metal via a coaxial cable. The Antenna BNC connector
should be wrapped in self amalgamating tape or the internal pin coated with sili-
cone grease if installed near SALT WATER.
If range is poor and interference from another source has been eliminated try
moving or re-orientating the receiver.
Specifications
Operating Voltage 9 to 24VDC, 9 to 18VAC
Current Consumption @ 12VDC Standby 14mA, All relays 56mA
@ 24VDC Standby 28mA, All relays 75mA
@ 16VAC Standby 28mA, All relays 73mA
Physical Dimensions IP65 Case 160mm x 90mm x 55mm
Antenna 200mm
Bulkhead case 108x70x34
Case Material ABS plastic
Output Channels 4
Output Ratings SPDT relay 1 Amp switching
maximum @ 24VDC.
Contacts are voltage free.
Reverse Polarity Protection Yes ( diode)
RF Operating Frequency 433.92mhz
RF Signal Type ( Data Transfer) On Off Keying ( OOK)
Keeloq
TM Code Hopping
Coding Combinations 4.2 billion
Learning Capacity ( RF Devices ) 170 fobs
Country of Manufacture Australia
Warranty
Microlatch Pty Ltd warrants this product to be free from defects in materials and
workmanship for a period of 1 Year from date of purchase. We will in the event
of failure repair or replace the product at our sole discretion. This warranty does
not apply in the event of accidental damage, abuse, misuse, non approved pur-
pose or act of God. This warranty is given in addition to any rights allowed by
Australian law.
Made in Australia
for
Microlatch Pty Ltd
N14528
Microlatch reserves the right to change specifications without notice in the interest of product development
REC-14
4 Channel RF Receiver Controller
© 2008 Microlatch Pty Ltd
Standard Version
( Indoor ) REC-14
IP65 Version
( Outdoor ) REC-14IP65
To Next Page
Need help?
General
