11
It is best to hold the HERBI 4 to the side or the rear so that the operator does not have
to walk over the treated area.
TO STOP SPRAYING
Close the flow valve and then
switch off the sprayer. When the atomiser disc has
stopped spinning raise the sprayer to an angle of 45
o
(see below). Never raise the
spray head until the atomiser disc has stopped spinning. Then
open the flow valve
and drain any remaining liquid in the feed tube back into the tank (by raising the feed
tube above the level of liquid in the tank). Then close the flow valve.
For ease of transport the tank can be disconnected (use the flow valve to isolate any
liquid left in a backpack) and the sprayer collapsed (by removing the batteries).
To Next Page
Loading...
