50200545-1/07.14
© 2014 Microsemi Corporation. All rights reserved. Microsemi and the Microsemi logo are trademarks of
Microsemi Corporation. All other trademarks and service marks are the property of their respective owners.
Microsemi Corporation (Nasdaq: MSCC) offers a comprehensive portfolio of semiconductor
and system solutions for communications, defense & security, aerospace and industrial
markets. Products include high-performance and radiation-hardened analog mixed-signal
integrated circuits, FPGAs, SoCs and ASICs; power management products; timing and
synchronization devices and precise time solutions, setting the world's standard for time; voice
processing devices; RF solutions; discrete components; security technologies and scalable
anti-tamper products; Power-over-Ethernet ICs and midspans; as well as custom design
capabilities and services. Microsemi is headquartered in Aliso Viejo, Calif., and has
approximately 3,400 employees globally. Learn more at www.microsemi.com.
Microsemi Corporate Headquarters
One Enterprise, Aliso Viejo CA 92656 USA
Within the USA: +1 (800) 713-4113
Outside the USA: +1 (949) 380-6100
Sales: +1 (949) 380-6136
Fax: +1 (949) 215-4996
E-mail: sales.support@microsemi.com
Common Issues
If the On LED does not light up after FlashPro5 driver installation, the driver might not be installed correctly and you
must troubleshoot the installation. For more information, refer to the FlashPro Software and Hardware Installation
Guide and the “Known Issues and Workarounds” section of the FlashPro software release notes:
www.microsemi.com/products/fpga-soc/design-resources/programming/flashpro.
FlashPro5 may not operate correctly if pin 4 of the JTAG connector is improperly used.
Documentation Resources
Refer to the FlashPro software page for further information:
www.microsemi.com/products/fpga-soc/design-resources/programming/flashpro
Technical Support and Contacts
Technical support is available online and by email.To find your local representative visit Microsemi SoC Sales offices,
including Representatives and Distributors which are located worldwide.
CE (European Conformance)
This product complies with the requirements specified in EMC Directive 2004/108/IEC and RoHS Directive
2011/65/EU.
To Previous Page
Loading...
