Microsemi SyncSystem 4380A - Page 6

[signal]
[avg] 4.520029449462891e+01
[desc] Good
[enum] 2
[freq] dual
[max] 5.070899963378906e+01
[min] 3.785400009155273e+01
[OK] 2016-01-06T19:05:02Z
The “desc” parameter within the satellite signal parameter family will read “Good” as shown
above if the C/N
o
values of the GNSS signals that are being received by the unit are within their
normal operating range. If the C/N
o
values are outside of their normal operating range but still
acceptable, the “desc” parameter will read “Fair”. If the C/N
o
values are low enough to
potentially cause performance issues, the “desc” parameter will read “Poor”.
Q11: How do I know how many satellites are being tracked by the SyncSystem 4380A?
A11: Initiate a Telnet communication session with port 1700 of the SyncSystem 4380A via the
Ethernet connection on the rear panel of the unit. Once at the “4380A>” command prompt,
enter status gps as shown in the example below:
4380A>status gps
[auto_positioning]
[time_remaining] 0 seconds
[mode]
[tracking]
[value] 4
[model]
[hw_version] OEM628-2.01
[name] G2SB0GTTN
[serial number] FBN15160339
[sw_version] OEM060220RN0000
[position]
[alt] 1.590260000000000e+03
[fixed] true
[lat] 4.001941930600000e+01
[lon] -1.052390921940000e+02
[satellite]
[number] 10
[signal]
[avg] 4.520029449462891e+01
[desc] Good
[enum] 2
[freq] dual
Number of satellites that are
being tracked by the unit.
Description of the overall
quality of the GPS satellite
signals that are being
received by the unit.
© 2016 Microsemi Corporation. All rights reserved. SyncSystem 4380A FAQs Version 1.0 (22 Feb 2016)
6