The power on of the receiver should be with the lever stick in idle position.
The glow driver monitors the voltage of the glow battery, there is no glowing.
Put shortly the switch THROTTLE CUT on and off and then the lever stick from idle to full
power and back to idle, then you are in the run mode. An external glow plug will not glow
because there is a reduced heating only.
Activating the start mode:
When you switch in run mode shortly from THROTTLE CUT off to on and back to off. The
glow plugs and the control LEDs are shining brightly and the status LED flashes red.
Transport and storage of the airplane :
Never leave the connected glow battery in the airplane, though there is nearly no leakage
current. It is for safety reasons.
Dimensions without connectors [mm] : 46 x 36 x 10
Weight : 23g
The optional accesssories consist of :
– Tool for opening the glow plug connectors
– Tool for pressing the SET button
– LED cable for red / green ultra bright status lightening
– Ground cable 0,7mm², 40cm, with a 3mm eyelet
– 2x Mounting screws M3x20mm, tooth disc and nut, all in stainless steel
To Next Page
Loading...
Need help?
General