Microsens MS657032X-24 - Page 6

Specifications
IEEE Standard
IEEE 802.3 10Base-T Ethernet
IEEE 802.3u 100Base-TX Fast Ethernet
IEEE 802.3ab 1000Base-T Gigabit Ethernet
IEEE802.3af for POE
IEEE802.3at for POE+
Network Connector :
1x RJ-45 10/100/1000Base-T Data
1x RJ-45 10/100/1000Base-T PSE with POE
Output power
Network Cable
UTP/STP above Cat.5e Cable
EIA/TIA-568 10-ohm (100 m)
Protocol
CSMA/CD
LEDs
PW1(power 1) Green: ON- power good, OFF-
power failed
PW2(power 2) Green: ON- power good, OFF-
power failed
Mode A : ON- End Span PD detected
Mode B: ON – Mid Span PD detected
4 Pair: ON – 60 W PSE in active mode
OFF – 30 W PSE in active mode
POE Pin Assignment
Default: Mode A (End Span) V+, V+, V-, V- for
pin 1, 2, 3, 6
DIP switch setting can be changed to Mode B,
V+, V+, V-, V- for pin 4, 5, 7, 8
DIP Switch
To select 2 pair (30/36 W) or
4 pair (60/72 W)
To select Mode A, or Mode B
To select standard IEEE802.3at 30 W or high
power POE 36 W
Reverse polarity protection
Present
Overload current protection
Present
Power Supply
2 Redundant power source
18..56 VDC Power Input
Power Consumption
1 W @24/48 VDC full load, without POE
POE power
Maximum POE power 72 W at 56 VDC input