Microtek Take-it D3 - Playback Mode

"
You can use the camera as a Web Cam, it allows you
to send live video streams to a Web page. To use the
camera as a Web Cam, you will need a computer, the
appropriate software, and an Internet connection.
To set up the camera for use as a Web Cam, follow the
steps outlined below.
1. Install the Camera Driver.
a) Turn on your computer, and insert the supplied
Microtek CD-ROM into the CD-ROM drive.
b) When the Microtek Software Installer screen comes
up, click Camera Driver, then follow the on-screen
instructions to install.
c) Click EXIT on the Microtek Software Installer
screen when the driver has been installed.
d) Restart your computer.
2. Set the camera to Web Cam mode.
a. Press the MENU button to enter
the Setup mode ( ).
b. Select    USB Switch, then
select Web Cam.
c. Press the MENU twice to exit the
mode menu.
3. Connect the camera to your computer, using the
provided USB cable.
 Connect one end of the USB
cable to the cameras USB
connector.
Web Cam (Windows Only)
 Connect the other end of the
USB cable to the USB connector
of your computer.
In a few moments, your computer will automatically
detect the camera.
A Web Cam screen appears, indicating that
connection is complete.
4. Position your camera to the person being
teleconferenced what you want to show.
5. Launch your Web camera software (e.g., Microsoft
Net Meeting) and start the video conferencing
function. If the software permits video recording,
you can save as recorded video in a file for later
use.
6. When finished, disconnect your camera from the
computer.
All manuals and user guides at all-guides.com