15
Turning Monitor On and Off
Connect the monitor to DC power. The monitor should come on within 10 seconds.
If the monitor does not come on within 10 seconds, press the power button on the OSD wired remote.
The monitor should power on within 5 seconds.
When the monitor is on, pressing the Power button will open a pop-up that asks, “Do you want to turn
off?” If yes, press the Power button again. Another popup says, “Please press the power button again.”
Press the Power button again to turn the monitor off.
Note: If there is no video input signal for a preset period, the monitor will automatically go into standby
mode. Allow up to 10 seconds for the video to reappear after the signal is reapplied.
To Next Page
Loading...
Need help?
General