Midea ATOM MDV-V28WDHN1 - Electrical Characteristics

Atom B Series VRF 50/60Hz
22
Midea Atom B Series Engineering Data Book
6 Electrical Characteristics
Table 2-6.1: Outdoor unit electrical characteristics
Model
Power Supply
1
Compressor
OFM
Hz
Volts
Min.
Max.
MCA
2
TOCA
3
MFA
4
MSC
5
RLA
6
kW
FLA
volts
volts
MDV-V28WDHN1(AtB)
50/60Hz
220-240
198
264
21.25
18.1
25
Soft start
9.45
0.08
1.0
MDV-V36WDHN1(AtB)
50/60Hz
220-240
198
264
28.75
24
32
Soft start
9.45
0.17
1.52
MDV-V42WDHN1(AtB)
50/60Hz
220-240
198
264
35
29
40
Soft start
12.3
0.17
1.52
MDV-V48WDHN1(AtB)
50/60Hz
220-240
198
264
40
33
40
Soft start
15.5
0.17
1.52
MDV-V56WDHN1(AtB)
50/60Hz
220-240
198
264
40
33
40
Soft start
15.5
0.17
1.52
Abbreviations:
MCA: Minimum Circuit Amps; TOCA: Total Over-current Amps; MFA: Maximum Fuse Amps; MSC: Maximum Starting Current (A); RLA: Rated Load Amps; FLA: Full
Load Amps
Notes:
1. Units are suitable for use on electrical systems where voltage supplied to unit terminals is not below or above listed range limits. Maximum allowable
voltage variation between phases is 2%.
2. Select wire size based on the value of MCA.
3. TOCA indicates the total overcurrent amps value of each OC set.
4. MFA is used to select overcurrent circuit breakers and residual-current circuit breakers.
5. MSC indicates the maximum current on compressor start-up in amps.
6. RLA is based on the following conditions: indoor temperature 27°C DB, 19°C WB; outdoor temperature 35°C DB.