Midea EGT 2.60 IX - Page 92

35






Step3:Adjustingthedoorspringtension

1.  Thedoorspringsareadjustedatthe
factorytothecorrecttensionforthe
outerdoor.Ifwoodenpanelsare
installed,youmustadjustthedoor
springtension.Turntheadjusting
screwtousetheadjustertotension
orloosenthesteelcable.
2.  Thedoorspringtensioniscorrectif
thedoorremainshorizontalinthe
fullyopenpositionbutfoldsupto
closewithalighttouchofthefinger.
Step2:installationofthepanel
Thewoodenpanelcanbeworkedaccordingtotheinstallationdrawings.
Semi-integratedmodel
MagicalpasterAandmagicalpasterBbedisjoinedon,magicalpasterAon
theaestheticwoodenpanelandfeltedmagicalpasterBoftheouterdoorof
dishwasher(seefigureA).Afterpositioningofthepanel,fixthepanelonto
theouterdoorbyscrewsandbolts(SeefigureB).