6
7. When installing the machine, please pay attention to the installation dimension in case of the
blocking of air inlet and outlet.
8. Drip tray cover must be properly placed inside the machine. No suspending in midair in case of
falling off.
10cm
10cm
9. Take out the pin of the quick joint at the rear of the product's base plate, and then take out the
blue plug.
Water pressure 0.1-0.4MPa
Tap water
Inlet
10. Insert the water inlet PE pipe in the quick joint, and tighten the pin.
11. The water cooler plug cord into a ground fault interrupter receptacle.
12. When installing filter and replace filter please turn off the water and power supply before
installation and replacement.
13. After installing ,supply power, and begin to use the Water purifier.
To Next Page
Loading...
