EasyManuals Logo

Midea KJ350G-S1 User Manual

Midea KJ350G-S1
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
6
Test Run
Attention
• This appliance has the function of disassembling protection, so it cannot be started normally until all air inlet
grilles are installed correctly.
• In case of continuous electricity, enter the working mode before the standby state, after each power on.
• The appliance is connected to the power again after unexpected power outage (when the power is off or the power
cord is unplugged during normal operation), and then restores to the working state before the power outage.
1
Flash for 1s
Preparation
Power on for the first time, the display panel flashes
for 1s, and then the screen is turned off. The whole
appliance is the standby state;
2
Remove the protective film of the filter
assembly.
3
Install the filter
4
On/standby
Press on/standby button
5 6
Warm up
When the particulate matter sensor enters the
warm-up state, PM2.5 numerical display shows "---",
and is normal after 10s.
Work
The purifier is powered on for
the first time and then enters
the automatic mode.
ON/STANDBY

Other manuals for Midea KJ350G-S1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midea KJ350G-S1 and is the answer not in the manual?

Midea KJ350G-S1 Specifications

General IconGeneral
BrandMidea
ModelKJ350G-S1
CategoryAir Cleaner
LanguageEnglish

Related product manuals