EasyManua.ls Logo

Midea MAW12HV1CWT - Product Installation; Tools You Will Need

Midea MAW12HV1CWT
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRODUCT INSTALLATION
WARNING - Before You Begin
Read these instructions completely and carefully.
• IMPORTANT - Save these instructions.
• IMPORTANT - Observe all governing codes and ordinances.
We recommend that two people install this product.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered under the Limited Warranty.
You MUST use all supplied parts and use proper installation procedures as described in these instructions when
installing this air conditioner.
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
Do not change the plug on the power cord of the air conditioner.
Aluminum house wiring may present special problems - consult a quali ed electrician.
When handling the air conditioner, be careful to avoid cuts from sharp metal edges and aluminum ns on front
and rear coils. Please wear cut-resistant gloves.
Bracket should only be used for its intended purpose. If not, the warranty will be voided.
Tools You Will Need
Phillips Screwdriver
Pencil
Drill and 1/8” drill bit
Level
Ruler or tape measure
Proper PPE
Flathead Screwdriver
Scissors or knife
12

Related product manuals