30
Cleaning the Drain Pump Filter
• Make sure that the machine has finished the washing cycle and is
empty. Switch it off and unplug it before cleaning the drain pump filter.
• Be careful of hot water. Wait for water cooling down. Risk of scalding!
• Clean the filter periodically every 3 months to ensure the normal
operation of the appliance.
1
2
3
Emergency
drain hose
Open the lower cover
cap
Pull out the emergency
drain hose, and take
off the hose cap
After water runs out,
reset the drain hose
5
4
Filter cap
6
Open the filter by
turning to the counter
clockwise
Remove extraneous
matter
Carefully reinsert the
filter and screw the lower
cover cap in clockwise
WARNING
CAUTION
• Make sure that valve cap and emergency drain hose are reinstalled properly, cap
plates should be inserted aligning to hole plates otherwise water may leak.
• Some machines don’t have emergency drain hose, so step 2 and step 3 can be
skipped. Rotate lower cover cap directly to make water run into basin.
• When the appliance is in use and depending on the programme selected there can
be hot water in the pump. Never remove the pump cover during a wash cycle,
always wait until the appliance has finished the cycle, and is empty. When replacing
the cover, ensure it is securely re-tightened.
To Next Page
